• All non-metallic. No nuts, bolts, washers or any other metal parts to corrode or degrade over time.
• Designed for carrier pipe diameters from 0.83" (21 mm) to 37.60" (55 mm) in diameter.
• Segmented pieces-small inventory may be used to accommodate a large variety of pipe styles, types and diameters. No extra trips from job site to warehouse for additional parts.
• Easy assembly. Simply slide the segments together and cinch tight with the patented Slide-Lock connecting system.
• Wide variety of runner heights to allow numerous options for pipe positioning within the casing.
• Runner variations may be used to adjust for grade.
• Will accommodate small conduit attachment for communications or electrical cable .
• Medi and Maxi segments, 2 molded runners per segment.
• Segment band and runners molded as one piece.
• Manufactured from UV resistant polypropylene.
• High impact strength, 1.5 ft. lbs/inch (0.8 joules/cm).
• Excellent compressive strength, 3,000 psi (211 kg/square cm).
• 800 Volts/Mil. Dielectric Strength.
• Wide temperature range, -22° to +212°F. (-30° to +100° C).
• Eliminates sand or grout fill.
• No special tools required for installation.
• Low coefficient of friction for ease of installation.

Targeted Use-Water        

• For carrier pipe diameters ranging from 0.83" (21mm) to 37.60" (955mm)
• For carrier pipe insertion lengths up to 400 feet. (121.9M)
• Spacing Recommendation: Max 8' (243.8cm) between spacers, Max 2' (61.0cm) from casing pipe end, Max 2' (61.0cm) on each side of bell or mechanical joint
• Recommended End Seals: Model C, S, W, and R.

Specifications

• Runners are available in a variety of heights to allow for desired carrier pipe placement in casing.
• Buckle with angled locking nubs.
• Slide-Lock is inserted into channel to close and lock the segments together. Slide-Lock removal and re-insertion will cinch the segments together for final tightening against carrier pipe
• Separate segments are connected by inserting the buckles into slots on the adjacent segment. Slot accepts Slide-Lock. Arrow molded on segment indicates correct insertion direction.
• Slide-Lock is used to tension the segments together after installation on pipe. Channels face up during insertion while the correct size Slide-Lock (micro, mini, midi, medi, maxi) is molded on the flat (bottom) side.