Brush

 Prepare FBE coating with a light sweep blast to remove gloss and roughen surface (approx. 1 mil). After sweep blast wipe entire surface with MEK or approved solvent to remove all dust and other surface contamination. Add the hardener to base and mix at a slow speed until a constant color is achieved making sure all sides of container are scraped. Pour mixed material onto surface and brush, trowel or roll to required mil thickness. A wet fi lm thickness gauge shall be used to measure mil thickness. If surface temperature falls below 50°F (10°C), surface should be preheated to achieve faster cure. Preheat may be achieved with a propane torch or induction coil. Resin and hardener component shall be kept warm, at a minimum of 60°F (15°C), to mix easily.

Spray

Prepare FBE coating with a light sweep blast to remove gloss and roughen surface (approx. 1 mil). After sweep blast wipe entire surface with MEK or approved solvent to remove all dust and other surface contamination. The equipment should be a plural component airless spray unit with a proportioning pump capable of a volume mixing ratio of 3:1. Standard ancillary equipment should include minimum 10 gallon hoppers, 2 ea. static mixers, 25 ft. max x 1/4" whip hose, and mastic gun with a 19 to 35 thou tip. (Applicator should consult with Denso regarding recommended equipment). Part A should be heated to 150°F -160°F (66°C - 71°C) and Part B heated to 110°F -120°F (43°C - 49°C). Hose bundle shall be set at 140°F -150°F (60°C - 66°C). A wet on wet spray technique should be used to achieve a minimum thickness of 30 mils. The coating thickness should be measured using a wet film thickness gauge.