Drive-In Magnesium Anode Features

• Need only a hammer and screwdriver

• One man installation in minutes

• No digging or augering of hole

• Eliminates thermite welding

Installation

• Extend the coild lead wire with clip out from anode.

• Select convenient location for the anode, a minimum of 18" from the service riser.

• Drive the anode with a hammer into the earth to approximate depth of 4-6 inches.

• Bury the anode lead wire from the anode to the riser at approximate 4-6 inch depth.

• Place the clamp around the riser 8-10 inches above ground level and securely tighten with a screwdriver.

• Tighten the set screw until it pierces the pipe coating and makes solid contact with the steel. Be certain the set screw head is fully secure against the J-clip speed nut.

• Coat the screw connection with Scotchkote electrical coating or similar coating.

• A pipe-to-soil potential measurement should be taken after connection to assure adequate cathodic protection is being achieved.